Making PC Engine HuCards

Main > Project Announcements

<< < (6/12) > >>

pbj:
Didn’t get to the calipers yet, but I did take a closer look at my Neutopia 2 card. The print is out of alignment on it, just ever so slightly - so the fingers are out of whack. If I recall correctly, I think they actually sent me 11 of the top boards. Guess one was a free misprint.

As for gluing, I’ve had good luck with a thin bead of super glue. Immediately putting the front edge of the cards against a flat surface, and using my hand to align the left and right edges. Then you sit there and feel like a trained monkey holding it tightly in place for a couple of minutes.

Anyway, just to further cement how dumb a project this has been, the clone Everdrives have been slightly revised and are down to $16 shipped. I’ve got three friends with this console and none of them can name any games they want. :timebomb:

Malenko:

--- Quote from: pbj on December 09, 2023, 11:17:19 pm ---Anyway, just to further cement how dumb a project this has been, the clone Everdrives have been slightly revised and are down to $16 shipped. I’ve got three friends with this console and none of them can name any games they want. :timebomb:

--- End quote ---

Saramander, Lords of Thunder, Ourun , Galaga 88 or 90 , Ninja Spirit , final lap twin , street fighter 2

I also need one of those controllers =)

EDIT: at $4 a pop I might want the whole library too

pbj:
Lords of Thunder is a CD. Burn your own.
Street Fighter 2 is impossible. Buy your own.

pbj:
Found calipers, confirmed on a couple of retail HuCards. 2.4mm thick.

pbj:
pdco_arcade, PCB Way is rejecting the bottom layer PCB - "Failed reason: Lack of the Silkscreen layer."

:dunno

Navigation

 Message Index

Go to full version