| Arcade Collecting > Restorations & repair |
| How to Wire a Power Strip Inside of an Arcade Cabinet? |
| (1/1) |
| fsmith2003:
I have recently added an audio amp to my Dynamo jamma cab which has a Peter Chuou power supply (usp-11-150x) installed. Right now I have the power cable for the amp running out of the back of the arcade alongside the arcades power cable. SO I am plugging those both into a power strip which I then plug into the wall. I would like to wire the amp into the power circuit of the existing jamma arcade so that I only have one cable coming out of the arcade that would need plugged in. I believe this could be done by adding an internal power strip inside the cab. I am not quite sure how this can be done though. Does anyone have any suggestions or pointers? |
| PL1:
--- Quote from: fsmith2003 on March 09, 2023, 08:14:55 pm ---Does anyone have any suggestions or pointers? --- End quote --- Check out the IEC power inlet section of the wiring entry in the wiki. http://wiki.arcadecontrols.com/index.php/Wiring#IEC_Fused_Power_Inlet_with_a_Lighted_Switch Scott |
| Mike A:
What kind of amp is it? If it is a 12v amp you have better options. |
| fsmith2003:
--- Quote from: Mike A on March 09, 2023, 11:12:38 pm ---What kind of amp is it? If it is a 12v amp you have better options. --- End quote --- Yes it is just a 12v amp. This one from Amazon is what I have. https://www.amazon.com/dp/B077Z7DBRT?psc=1&ref=ppx_yo2ov_dt_b_product_details |
| Navigation |
| Message Index |