Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Joystick Installation Bushing  (Read 536 times)

0 Members and 1 Guest are viewing this topic.

Tommy714

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 47
  • Last login:June 14, 2023, 05:17:15 pm
  • I want to build my own arcade controls!
Joystick Installation Bushing
« on: January 24, 2023, 06:08:30 pm »
Ok, I happen to have a lathe at my disposal, so it's a little easier for me to make one of these really quickly.

The I.D. is .5195 (just a couple thousandths over the size of the joystick stem)

The O.D. is 1 1/8" (just a couple of thousandths under) to match the hole drilled in the control panel

Put it over the joystick stem, put it in your control panel.  Now the joystick is centered in the opening perfectly and can be mounted to the control panel.

Remove the bushing and install your dust plate and knob.
« Last Edit: January 25, 2023, 10:30:30 pm by Tommy714 »
Logged
Pages: [1]
  
Go Up
« previous next »