Main > Consoles
Neo Geo
chopperthedog:
--- Quote from: PL1 on September 10, 2022, 07:51:08 am ---
--- Quote from: chopperthedog on September 09, 2022, 10:21:24 pm ---The actuator never touches the plate, the switches become the "gate".
--- End quote ---
The one PBJ asked for is a different design (smaller plate corner radius and 3d printed instead of laser-cut/milled acrylic) but the gate is the same size as the one in your video.
We'll see if it is the right size.
--- End quote ---
Top image is from the 3d print you linked which looks like how my piece of acrylic SHOULD look. So, if you didn't make the gate bigger and printed that as is, pbj should be happy.
Found this other print file, judging by the comment it's to the same specs as my worthless acrylic piece. https://www.thingiverse.com/thing:4333474/comments
good day.
Malenko:
--- Quote from: KenToad on September 09, 2022, 01:12:07 am ---Pic attached of what I did to my Neo Geo X stick. Sanwa buttons are a lot snappier than stock in this case. The bigger issue is that I can't find a decent spring to replace the crappy lightweight spring in the stick. I have a heavier spring coming from the UK that is reported to work, but shipping is taking forever.
--- End quote ---
Just needs a custom red and white vinyl to make it look like a neocab
PL1:
--- Quote from: chopperthedog on September 10, 2022, 10:55:26 am ---Found this other print file, judging by the comment it's to the same specs as my worthless acrylic piece. https://www.thingiverse.com/thing:4333474/comments
--- End quote ---
There was no file update after that comment.
Comparison print in progress.
We'll know how the two models compare in a couple hours. :cheers:
Scott
PL1:
PBJ model print:
- 16.62mm point-to-point on octagon
- 15.50mm flat-to-flat on octagon
- 2.24mm thick plate
Chopper model print:
- 19.62mm point-to-point on octagon (1.5mm more from the center to the gate)
- 18.45mm flat-to-flat on octagon (1.475mm more from the center to the gate)
- 2.16mm thick plate (0.08mm thinner plate)
How do those measurements compare with your "worthless acrylic piece", Chopper?
Scott
lilshawn:
maybe the original makers stick had a larger actuator on it... thus making the size of octagon appropriate... it's possible in later (or earlier revisions) there was a change in the actuator size.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version