Main > Consoles

dreamcast to arcade monitor picture is halved...

<< < (2/2)

tenex2mg:
Thanks for the replies, well I guess I did a temporary hack because it was working perfectly for a couple of days (on the arcade monitor), it sorta petered out when I hooked up the audio..where could I get a pic of the inside of the dreamcast so's I could follow snaaake's advice and disable the 31khz output.

as always thanks,

-jeff-

Dave_K.:
I don't know why snake would want to do something like disable the 31khz inside the DC motherboard!?  Unless he ment inside the VGA box.  There is absolutely no reason to do this inside the DC itself!  Just cut a single wire inside your VGA box and thats it...no solder, nothing else...just put the screws back in and you are done.

I guess the only had part is cutting the correct wire #7 (trace it from the dc connctor into the vga-box's pcb.  If you cut the wrong one, then just twist/splice it back together.  

SNAAAKE:

--- Quote from: Dave_K. on March 04, 2004, 09:51:30 pm ---I don't know why snake would want to do something like disable the 31khz inside the DC motherboard!?  Unless he ment inside the VGA box.  There is absolutely no reason to do this inside the DC itself!  Just cut a single wire inside your VGA box and thats it...no solder, nothing else...just put the screws back in and you are done.

I guess the only had part is cutting the correct wire #7 (trace it from the dc connctor into the vga-box's pcb.  If you cut the wrong one, then just twist/splice it back together.  



--- End quote ---

I never found the wire on the vga box itself ???
I am too impatient and I have 2 DCs so whatever but thats just me.

Navigation

[0] Message Index

[*] Previous page