Took about 8 months off working on my pedestal/arcade/pinball setup. Just now getting back into it and finally messing with my servostik. Installing the motor and run the test application and not getting anything once i hit the 8way button. The motor on the switch is not moving at all. I even uninstalled from under the control panel and it is not moving with anything attached to the arm. I get the windows notification when i plug the USB in. I hit 4 way in the servostik.exe and it highlights yellow. I hit the 8way button and nothing. Could i have a bad motor? And i figured i should mention is running it off a laptop the issue? Figure i wouldnt mention incase power issue.
Thanks
Tony