I picked up a Merit Scorpion 9000 dart board. It seems to be close to 100% with one big exception - it won't register bullseye hits. I was able to determine that it is not the board but using alligator clips on the (from right to left) pins 2/4 and pin 20. However when the matrix ribbon cable connector is plugged into the pins I get nothing. Below are some photos of the condition of my ribbon cable.
Can anyone tell how I disconnect the ribbon cable from the connector so I can see if it is a connector issue? And if it isn't, how can I splice or repair the FFC so I can get the bully to register.
Thanks in advance for any help.
Scott