| Main > Main Forum |
| Building a Star wars yoke from scratch |
| << < (19/25) > >> |
| Generic Eric:
Menace, who long do you think it would take to build the yoke from scratch? Has anyone built a yoke based on this guide? Geez...I am crazy...the guide was posted for less than a day, and I am asking if anyone has built one yet... Call me a wanker. |
| Tiger-Heli:
--- Quote from: froggerman on March 18, 2004, 03:34:59 pm ---Thanks wj2k3. That is the Star Wars yoke overlay. I was looking for the Return of the Jedi yoke overlay that is shown on the yoke earlier in this thread. --- End quote --- There's a very high-res one here: http://www.arcadecollecting.com/caga/unclean/ It was there before Brax posted his, though, I'm pretty sure. |
| Brax:
--- Quote from: Tiger-Heli on March 18, 2004, 04:24:59 pm --- --- Quote from: froggerman on March 18, 2004, 03:34:59 pm ---Thanks wj2k3. That is the Star Wars yoke overlay. I was looking for the Return of the Jedi yoke overlay that is shown on the yoke earlier in this thread. --- End quote --- There's a very high-res one here: http://www.arcadecollecting.com/caga/unclean/ --- End quote --- Hmmm, it didn't seem to upload. But, yes thats where I found it quite some time ago. I was trying to post it to the non-vector category, hoping someone might vectorize it. :) It was there before Brax posted his, though, I'm pretty sure. --- Quote --- --- End quote --- |
| menace:
--- Quote ---Menace, who long do you think it would take to build the yoke from scratch? --- End quote --- hmmm.. hard to say. I built it over the course of a few weeks with an hour here and there. there were also pauses so that the construction didn't get ahead of the write-up. If you have all the parts on hand, i can't imagine it would take that long. As far as the art goes, I liked the look of the jedi one better just cause it had a bit more color. Either way it will have to be deformed in photoshop since my yoke isn't the exact same size or shape as the original. |
| Generic Eric:
Menace Do you have an estimate on the materials (not including "prototyping cost) to make a yoke based on your design? I know that you said not any part over $10. Good Stuff! |
| Navigation |
| Message Index |
| Next page |
| Previous page |