| Main > Main Forum |
| Question: How thick should the Plexi be for the Monitor Bezel |
| << < (2/4) > >> |
| Jabba:
--- Quote from: CitznFish on February 28, 2004, 12:59:56 pm ---a lot of people use 1/8" if you spent a lot of time on your cab you're not going to punch the monitor. Hope that helps. --- End quote --- OK, OK. I have taken my anger management course and feel I can hold my self back a little LilWolf when the Mutants start hoarding >:( So 1/8" is the norm. Does it sway at all in the middle or should I care? Has anyone used dark tint on the back side? If so, is it hard to install? |
| dirt:
i tried to use thicker than 1/8 and you can actually see waves in it >:(. stick with the thin stuff. dirt |
| General Zod:
Are you sure you want to go the plexi route? I've had better success in the long run spending a little more up front and getting a piece of tempered glass for the bezel. You can even get the glass smoked, which will also cut down on eye strain. Just my two cents. ;) Mike |
| unclet:
I used 1/4" plexi and it looks fine. I guess I did not want to go with 1/8" (which I did use on my control) for the monitor bezel since it seems to flimsey(sp?) to me. |
| patrickl:
Yeah, glass sounds better to me too. Plexi might work fine, but glass is even better. |
| Navigation |
| Message Index |
| Next page |
| Previous page |