Main > Woodworking

Drilling button holes?

<< < (5/8) > >>

Gilrock:
I've had this Forstner bit set on my Amazon Wish List but never could pull the trigger to spend that amount but they look nice.  They even have the hex shaft you wanted.  There is also a filler set to give you the 1/16" in between ones.
https://www.amazon.com/dp/B0007D2Y5E/?coliid=I2D8S9MFD9GR3C&colid=1CRAEE2YF3540&psc=1&ref_=gv_ov_lig_pi_dp

slybunda:
Priced way too high for me. I got the £7 kit on order so will see how that works out.

Mike A:
You will be fine.

You don't need to use the same bits that Mr. Moneybags is looking at.

I am still trying to figure out how to make Gilrock my sugar daddy.

slybunda:
How does one drill a square hole for those gambling machines i see?

bobbyb13:

--- Quote from: Mike A on October 28, 2021, 12:01:24 pm ---You will be fine.

You don't need to use the same bits that Mr. Moneybags is looking at.

I am still trying to figure out how to make Gilrock my sugar daddy.

--- End quote ---

 :laugh2:

I'm all about having good tools.
That is a nice looking kit Gilrock.

If I had unlimited funds I would be a menace to my family via my workshop.

Those rectangluar buttons I believe use round mounting holes also.

Navigation

[0] Message Index

[#] Next page

[*] Previous page