Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up --- Bug Reports --- Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


Author Topic: Galaxy Top Gun dart board startup issues  (Read 3537 times)

0 Members and 1 Guest are viewing this topic.


  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 1
  • Last login:October 21, 2021, 01:19:43 pm
  • I want to build my own arcade controls!
Galaxy Top Gun dart board startup issues
« on: October 21, 2021, 10:51:04 am »
I have a galaxy top gun dart board I recently bought.  It powers up fine, gets to the self test screen where it says hit select to continue, but when i hit the select button, it just buzzes and then restarts.  Maybe once out of 10 times it will actually continue and then it works.  Just not sure where to start trouble shooting. 


  • Keeper of the __Blue_Stars___
  • Trade Count: (+17)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4521
  • Last login:January 10, 2023, 01:42:05 am
  • Insufficient facts always invite danger.
Re: Galaxy Top Gun dart board startup issues
« Reply #1 on: December 24, 2021, 01:58:25 am »
Sounds like you might have a faulty power supply. However, first thing to check is all the connectors. These games are old, so connectors work loose and get dirty/corroded. Clean all the contacts and re-seat everything. I like to use this stuff for cleaning the contacts:

If that doesn't do it, I would next check the power supply as there is a chip on the board that checks for out of tolerance power supply conditions. If it detects it, the board will reset. Look for the output on the power supply, it should be labelled J2. Verify pin 1 is outputting 12 volts and pins 2 and 3 are outputting 5 volts.