Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up --- Bug Reports --- Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Aurora monitor backlight inverter kills Power supply  (Read 3196 times)

0 Members and 1 Guest are viewing this topic.

popcorn1

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 4
  • Last login:October 02, 2021, 01:01:06 am
Aurora monitor backlight inverter kills Power supply
« on: October 02, 2021, 12:53:48 am »
The inverter board for the backlight on the monitor (FS-S190AB) is preventing the game from booting.  It causes the PS to shut down after a few seconds. Unplugging the inverter board allows the PS to stay running. I found the 4 caps on the board were all bad and replaced them but the bad caps must have allowed damage to something else as the PS issue remains. Different PS does the same thing.

I would absolutely consider using a LED backlight replacement (if such a thing is possible) but there is a whole lot more components and wires on this board than required to just drive a FL tube. It must do more than that? There is power, 4 output connectors and a 12 pin connector.

Anyone have any guidance they can offer?

lilshawn

  • Moderator
  • Trade Count: (+3)
  • Full Member
  • *****
  • Offline Offline
  • Posts: 6861
  • Last login:Yesterday at 10:11:15 pm
  • I break stuff...then fix it...sometimes
Re: Aurora monitor backlight inverter kills Power supply
« Reply #1 on: October 10, 2021, 06:48:48 pm »
Yep probably a shorted driver IC in the inverter board. Not worth fixing now.

Replacment plug and play inverter is about 40 bucks for an equivalent

Universal 17-21in display inverters are about 15 bucks on eBay... But you'll have to run new wire and tap it in to 12v but they work just fine.

The 4 small connectors are your CCFL tubes the don't letter which plugs into where.... The other cable carries 12v, ground, a signal wire to turn on the inverter, and a brightness wire.