Hey all - I'm attempting to restore a jamma cocktail table that's been sitting in storage for several years. Coin door harness was cut so I don't know what the normal state of it is, nor do I have any sort of standard connector for my jamma harness.
It looks like the previous owner wired the two wico coin mechs together to feed into the single coin1 jamma input, so my understanding is each mech should have two wires, which should be the daisychained coin1 (green wire) and a ground (the two white striped wires), no? But then I'm unsure what the purpose of the area I've highlighted in green is (with the outgoing purple wire, which I assumed would be coin1 given that the green wires converge there). Any help very much appreciated.
Photos:
https://imgur.com/a/AsXGmFWAlso! I've been trying to identify the table itself (in its original form), as it seems to be a horizontally-oriented table rather than a vertical one which is what I've seen in most cases. Any clues? It seems to have been gutted and repurposed a few times, though I suspect that's not unusual...
In any case, thanks again in advance for any help / advice!