Main > Monitor/Video Forum
Hantarex Polo 25 not sharp image.
vbobrusev:
Hi! And sorry if it's stupid or common question, but I am absolutely zero in restore arcade monitors. I just purchased MK2 cabinet and it has Polo 25 Monitor. I have boards from WWF Midway and connect it to cabinet. When I turn on power it shows not sharp image. I recorded video and upload it here. https://cloud.mail.ru/public/pdQs/YLQzidCRo I am tried adjust it via monitor remote control, but no luck... Any ideas what it can be?
Thanks!
Ropi Jo:
Have you tried the focus control on the flyback (loptx)? It's the large (usually black) component with thick red cables going to it.
CAUTION.... high voltages!!! Be sure to wear rubber sole shoes and keep 1 hand in your pocket. If there is a slot in the control then use an insulated screwdriver.
vbobrusev:
--- Quote from: Ropi Jo on July 27, 2021, 01:30:13 pm ---Have you tried the focus control on the flyback (loptx)? It's the large (usually black) component with thick red cables going to it.
CAUTION.... high voltages!!! Be sure to wear rubber sole shoes and keep 1 hand in your pocket. If there is a slot in the control then use an insulated screwdriver.
--- End quote ---
Thanks for advice! I didn't know about it, it's ok if I will do it with rubber isolated screew driver and will have rubber gloves?
Any other safety advices?
vbobrusev:
It works! Thanks! But on bottom it have black area and I can't adjust it via remote control. I can adjust wide and horizontal positions, as I remember I have adjust height but I can't adjust vertical position, where I can do it?
Ropi Jo:
Somebody more experienced with this particular chassis will need to advise you on adjusting the V position, but it's getting closer!