Arcade Collecting > Merit/JVL Touchscreen
Issues with JVL Retro Machines
mahkeymike:
I don't know about the sound driver error, did you try using the working CF card. I seen weird errors when CF cards have bad sectors, but most likely the ioboard is either not plugged in or it went bad. I woyuld rule out everything else before replacing the motherboard as it doesnt seem like its the cause. I would check all the wiring to make sure everything is plugged in.
RockyOBX:
I've Frankensteined so many parts from these four JVLs plus a few spare Vortex boards, but the errors always remain the same dependent on which motherboard I'm using. I also tried various CFs, but still no go. I do have a vortex board that boots right before the JVL loading screen and then crashes to "No Signal" and tries to boot again, so I'm going to look more into this board tomorrow. I've tried two CFs on it so far and both result in the same crash.
mahkeymike:
Well if your sure its the motherboards, then the IOboard error would have to be something wrong with the onboard usb controller. Either way, you will have to buy a replacement motherboard which looks to be selling for $150+ on ebay. Good luck.
Megatouchmike:
Have you tried getting into the bios to ensure the onboard audio and USB are enabled?
RockyOBX:
Reading again over your posts about the I/O error, I decided to use my complete working set of boards on this JVL Retro shell that I've been testing everything on. Dang I/O error now cropped up with this working set, so I believe the JVL Retro case I'm using has a bad cord with a split that travels between the motherboard to I/O board. I think the sound errors must load prior to the I/O check, which is why this threw me off with variable errors dependent on motherboard. Used a different JVL Retro case and everything boots up perfectly, so now this will be my new testing shell.
As for the BIOS, I totally overlooked checking out the settings to make sure everything is enabled properly. I plan to get back to these on Thursday and will post updates.
Thank you again for everyone's help and input thus far.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version