Arcade Collecting > Restorations & repair

RUSH 2049 Resurrection

<< < (10/10)

Thank ya, thank ya very much...

It has been quite a trip.
Pales in comparison to Arroyo's work on his EDOT!

And I appreciate your confidence in my developing pcb skills Andrew!
I've been so busy with work and homestead activity that I have had scant time for any fun at all.
My soldering IS improving enough to tackle a chassis repair without destroying it at this point I think.

When I get back from Zapcon and catch up on the work I have been putting off I will take a shot at it.
Diagnosis will be the biggest hurdle.
I'm going to start with a K7000 I have since I have pretty good documentation to get started at least.

I need to find some tubes that aren't 27" and bigger!
The only ones I have seen pop up recently are 32 (which I have two of already!) and 36 (and the one of those I have is more than enough.)

Mike A:

--- Quote ---When IF I get back from Zapcon
--- End quote ---


--- Quote from: Mike A on April 27, 2022, 12:26:52 pm ---
--- Quote ---When IF I get back from Zapcon
--- End quote ---

--- End quote ---


I NEED to get home so I can finish fixing/building all this ---steaming pile of meadow muffin--- I have going on here already or the fabric of the universe may unravel.

Mike A:
I make no promises.


[0] Message Index

[*] Previous page

Go to full version