RUSH 2049 Resurrection

Arcade Collecting > Restorations & repair

<< < (10/11) > >>

bobbyb13:
Thank ya, thank ya very much...

It has been quite a trip.
Pales in comparison to Arroyo's work on his EDOT!

And I appreciate your confidence in my developing pcb skills Andrew!
I've been so busy with work and homestead activity that I have had scant time for any fun at all.
My soldering IS improving enough to tackle a chassis repair without destroying it at this point I think.

When I get back from Zapcon and catch up on the work I have been putting off I will take a shot at it.
Diagnosis will be the biggest hurdle.
I'm going to start with a K7000 I have since I have pretty good documentation to get started at least.

I need to find some tubes that aren't 27" and bigger!
The only ones I have seen pop up recently are 32 (which I have two of already!) and 36 (and the one of those I have is more than enough.)

Mike A:

--- Quote ---When IF I get back from Zapcon
--- End quote ---

bobbyb13:

--- Quote from: Mike A on April 27, 2022, 12:26:52 pm ---
--- Quote ---When IF I get back from Zapcon
--- End quote ---

--- End quote ---

:lol

I NEED to get home so I can finish fixing/building all this ---steaming pile of meadow muffin--- I have going on here already or the fabric of the universe may unravel.

Mike A:
I make no promises.

bobbyb13:
Man, has it been a while.
I finally got back a compatible chassis for this that I sent out months ago.
It needed more than just a cap kit- that at least I am now capable of- and it was too damn hot today to do anything out in the sun so I thought what the hell.

I needed to make some harness adjustments to get everything connected properly but after double checking the boardset (it ran before with no errors at least!) I fired the whole thing up and was rewarded with great sound and a pretty decent image- which hopefully I can dial in with a little effort.

It gave a warning that the wheel is not responding so I will have to do some investigation.
The coin vault is gone and although I have the coin door assembly it is a mess so that needs so work too.
It won't coin up, even from the test switch board, so I need to sort that also.

Not 100% yet, but very encouraging.
Maybe before the end of THIS year I can get some linked play going on with the other one?!

Navigation

 Message Index

Go to full version