GUN2CRT, the new universal CRT lightgun adapter

Main > Lightguns

<< < (20/25) > >>

Marsupial:

--- Quote from: JayBee on June 06, 2021, 09:58:42 pm ---
--- Quote from: Marsupial on June 06, 2021, 09:49:32 pm ---That's what I meant, I already poked at the guts of the gun when looking to change the board from their gen 1 to newer model.

http://forum.arcadecontrols.com/index.php?topic=165030.msg1739986.msg#1739986

It is an analog light sensor with zero logic in the gun, the cable is directly connected to the sensor - gnd/5v/sig

The buttons are actively connecting to ground when pressed.

--- End quote ---
I see. There are still various kinds of 3 pins sensors tho, with this 3 pins it could be logic state or analog, and checking if it's active low or active high is still needed ;)

--- End quote ---
Being that it was sold in early 2000, I'd bet it's a plain analog sensor, but haven't made specific measurements on it.
Let me know if there's any measurements I can do that would help...

dmckean:
The Guncon I ordered from Japan finally arrived, I'm so ready for this!

josete2k:
Can't wait for ordering...

Purple Tophat:
Well, here I am trying to get my USB2Gun system finally set up correctly and really struggling to get recoil working and to calibrate the damn Guns properly, but now it seems that that whole setup might be obsolete. Will your system be compatible with Happ guns? You think this is something you might be offering soon? I’d be in. I’ve wanted a good CRT light gun cab for a loooong time and I’m just not having luck getting the USB2Gun working right. I’m not good with the stuff like so many on this board. Anyway, sounds like great work! Looking forward to a finished product!

Moksi:
i just bought a crt bang olfuson that happens to just fit right in the cabinet.
i was already thinking ahead with led sensor where to put the sensor, this solution comes at the perfect time if no sensor is needed and accuracy is perfect

Hope to see the project soon

Navigation

 Message Index

Go to full version