Main > Main Forum
found a source for multi-color wire... DUH!
<< < (4/4)
nipsmg:
I used all black too..

Here's my problem, however:

I temporarily printed my CPO on a crappy inkjet plotter.. It's very dithered, and while from a distance it still looks great under the plexi, up close it starts to look crappy.  Also, I ran out of funds before getting all of the correctly colored buttons, and eventually have to remove the plexi and CPO to put in the new CPO when I get it.

What I'm worried about is... I'm going to have TONS OF MICROSWITCHES, not connected to buttons, ALL WIRED THE SAME COLOR.  I guess I could turn on the computer and manually click them to find out where they go, but it's going to be a nightmare.. I REALLY wish I had done it differently now.

--NipsMG
eightbit:

--- Quote from: nipsmg on February 24, 2004, 09:06:02 am ---What I'm worried about is... I'm going to have TONS OF MICROSWITCHES, not connected to buttons, ALL WIRED THE SAME COLOR.  I guess I could turn on the computer and manually click them to find out where they go, but it's going to be a nightmare.. I REALLY wish I had done it differently now.
--- End quote ---

This is easy, don't disconnect the wires from the switches. Simply label the switches when you pop them out of the buttons.
Navigation
Message Index
Previous page

Go to full version