| Main > Main Forum |
| Restoring Pole Position Wheel |
| (1/4) > >> |
| Minwah:
I have an old Pole Position wheel which is OK but a bit rusty. Unfortunately the chrome has rusted passed the stage that it can be cleaned up. I could pretty easily get the rust off with wire wool and / or sandpaper. Then I suppose I could just spray paint it black or something. I would ideally like to get it re-chromed, but I am not sure if this is possible with the dip-coated rubber coating around the 'wheel' part (?) Any suggestions? |
| dirt:
you cant rechome it without taking off the rubber part. my suggestion would be use a 4" grinder with a soft sanding disk on it and take off all the rust and scuff up that chome so you can paint it. dirt |
| Minwah:
--- Quote from: dirt on February 22, 2004, 06:26:05 pm ---you cant rechome it without taking off the rubber part. my suggestion would be use a 4" grinder with a soft sanding disk on it and take off all the rust and scuff up that chome so you can paint it. --- End quote --- I was afraid of that :( I'll have a go at painting it then, thanks for the reply :) |
| SirPeale:
I suppose if you're looking to make it look 'factory' you never will, unless you know how to get that coated look. But this is what I would do. 1) tear the coating off. 2) have it sandblasted to get the chrome off. 3) have it rechromed 4) use a steering wheel cover. One of the nice leather ones. At least, that is what I would do, if I had the $$$. What is the original cover/coating like? Is it foam rubber, rubber, ??? |
| JustMichael:
I wonder if the coating on the wheel is similar to the rubber coatings you can apply to common household tools? |
| Navigation |
| Message Index |
| Next page |