Setting up Mame / Mala with rotating CRT (Mrotate4)

Software Support > Automated Projects

<< < (14/22) > >>

Ropi Jo:
All getting closer. Serial card had arrived.

I tried to open the vertical layout in malalayout but it's not making much sense to me. I'll have to get my son to have a look.

DaOld Man:
Two comports.
I made a tester that plugs into my comport, with two leds so I can monitor the outputs.
The outputs blink on power up, and also do a very quick blink on power down. But the card you bought may act different.
If it becomes a problem you can try the other port. It may act differently. (I only have the one port.)

Ropi Jo:
A very busy weekend doing the wife's chores.

I didn't get a chance to try Mrotate with the new serial card.

And didn't get a chance to finish the auto degaus circuit.

But this evening I came indoors from the garden (yard) to run a bath and asked my son to look at the H and V layouts in Mala. Showed him what the issue was and left him to it. Before my bath was run he'd fixed it. I now have snaps on H and V so very happy.

It's strange that all 4 downloads of Mala 174 (from various sources) and the Mala I downloaded about 7 yrs ago all have no snaps in V without making changes to the V layout.

Ropi Jo:
More delays.

The wife's car got dragged home by a recovery truck today so that's my weekend plans screwed. So close!

DaOld Man:
Sorry about your wifes car.
I understand how life can get in the way of our hobbies.
Take your time, but dont forget to update us on any progress you make on your project.

Navigation

 Message Index

Go to full version