| Main > Main Forum |
| Parallel Cable cut away |
| (1/3) > >> |
| GGKoul:
Hello I search the board & internet and I couldn't find the answer to this. Can someone send me a link that describes what wires are in a parallel cable? As I planning to create multiple panels and I want to connect the panels via a Male & Female parallel cable. So each panel will have a Male parallel cable to connect to the Female connection from the IPAC. Any advise you have will be greatly appreicated!! Thanks! -GGKoul |
| Jake22:
There's no standard for the actual cable itself. However, the port pinouts are in these places: http://www.doc.ic.ac.uk/~ih/doc/par/doc/regpins.html http://www.physics.utah.edu/~ko/WebEshop/E-stuff/pinout_parallel.html |
| SirPoonga:
There's just 25 pins/wires. Do with them as you please. |
| GGKoul:
So the Pins on both the Male & Female cables don't have to match? IE: Pin1 Male to Hole1 on Female? I mean this.. A wire a on connected to the male end is pin 1 and wired to UP... Hole1 on the female is wired to the IPAC as Button1. So they dont have to match? |
| GGKoul:
So I'm wondering... Is there a document that says White Wire is Pin 1 Blue Wire is Pin 2 |
| Navigation |
| Message Index |
| Next page |