| Arcade Collecting > Restorations & repair |
| Ms. Pac-Man joystick hole diameter and possible hacks in the mean time? |
| (1/1) |
| francoisadt1:
Hi Gamers Standard questions: a) What is the standard diameter of a Ms. Pac-man joystick need to be to remove dead zones? b) What is the shaft length of Ms. Pac-man joystick above the control panel? c) What is the normal thickness of Ms. Pac-Man control panel wood to be? d) What can I do to my the response quicker/faster a quick throw? How much of a "padding" must I add below the Control Panel so that the shaft is shorter for quick throw? What must the non-standard diameter of the joystick shaft be in the control panel then? What to do next:? Currently I do have a custom self made control panel with diameter about 26 mm (1.01 inch). When I move / play the joystick it is if the joystick slips when move from right to left, it also get stuck a but once moved left. So the move from right to left, to down - slips or stuck, the reaction is not quick enough allmost a deadzone..? So I want to fix the whole making it bigger or smaller. My currently hole is about 28mm (1 inch and fraction 1/8), the distance from the joystick ball to control panel (joystick shat below the red ball) is about 22mm (0 inch and fraction 7/8 inches) . The control panel about 22mm (0 inch and fraction 7/8 inch) Will it work better if I just add a small square inside the hole (like a restrictor plate would have done but just inside the whole) to force the direction? Or must I rather make small pathways for each direction (about 3mm) inside the control pabel hole at the bottom? Regards Francois du Toit |
| Navigation |
| Message Index |