| Arcade Collecting > Restorations & repair |
| WWF Wrestlemania restoration: getting 'er back into the ring |
| (1/6) > >> |
| mourix:
Good evening ladies and gentlemen, this is Mourix. WELCOME TO WRESTLEMANIAAA :banghead: :timebomb: Oh boy... he aint lookin so good :'( Time for a new project to make this cabinet great again. Let's go over the list of things that need to be sorted out: * Monitor dead * Power supply dead * Jamma pcb state unknown * Controls busted * Coin doors rusty * Missing locks * Monitor bezel glass scratched up * Control panel plexiglass busted * Locks missing Besides of the above, the artwork is in good condition and there is surprisingly little water damage. The next couple of months I will have loads of lockdown time to get this all done :cheers: |
| mourix:
With these restorations I always like to start with the game PCB, as it's the only part that truly can't be substituted with new parts. I built a jamma test rig with a scart TV and pc power supply. Wow, it actually works! I did have to glue all the ROM labels as they were falling off, put in a new CMOS battery and replace the single electrolytic cap while I was at it. |
| Mike A:
Sweet. I will be watching. :applaud: |
| mourix:
With this cabinet came a great amount of documentation in mint condition. Most of these documents aren't fully available online, so I painstakingly scanned everything and made it into proper PDF's. I'm contemplating on scanning my cab's sideart too, any interest? Midway WWF Wrestlemania Dedicated Game Operation Manual Midway WWF Wrestlemania QA Registration Card Midway WWF Wrestlemania Tamper Screws Notice Midway WWF Wrestlemania Coin Door Field Installation Instructions Hantarex Polo Service Manual 10"-33" Multilingual Hantarex Polo 25" RCA USA Schematic |
| PL1:
Great scans. :applaud: Scott |
| Navigation |
| Message Index |
| Next page |