Software Support > GroovyMAME

crt emudriver 2.0 groovymame 0.194 win 10 x64

(1/2) > >>

mitsurugi:
Hi.

I have installed crt emudriver 2.0 on win 10 x64 and no problem with 15 khz and most emulatores but... groovymame 0194 flick image (not showing ant 15khz) Are compatible or must install last version?

Another problem is supermodel 3 emulator not showing in 15khz (same as groovymame flickering image)...

Thanks!!

mitsurugi:
With a fresh 0.219 Groovymame version it works fine! All emus works fine in win10 x64 except supermodel.

Supermodel testing different resolutions and disable ati service runs at half speed... I will keep tryiing solve the problem >:D

psakhis:
Hi, for supermodel you need to config alternative resolution. The emulator takes 640x480@30hz modeline by default.

For example, i have 704x480. This is my command argument: supermodel_729.exe %1.zip -res=704,480 -fullscreen -stretch

Note: I only have 704@480@60hz installed as well.

haynor666:

--- Quote from: mitsurugi on April 10, 2020, 01:46:42 pm ---With a fresh 0.219 Groovymame version it works fine! All emus works fine in win10 x64 except supermodel.

Supermodel testing different resolutions and disable ati service runs at half speed... I will keep tryiing solve the problem >:D

--- End quote ---

The same problem here - if I force supermodel to work with interlaced resolution then it works at half speed :/

Looks like my hardware after all does not have enough power simply :/

Milsancho:
So which hardware are you using currently? Supermodel was one of the things I wanted to use on the setup I'm building.

Navigation

[0] Message Index

[#] Next page