Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Golden tee fore complete problem  (Read 712 times)

0 Members and 1 Guest are viewing this topic.

GMZombie

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 379
  • Last login:March 22, 2022, 10:11:23 am
  • I am a living Legend who fixes stuff... mostly
Golden tee fore complete problem
« on: January 28, 2020, 05:34:21 pm »
Ok what i have here is a gt complete that wont boot up. It does reboot sometimes after finding the hard drive but if i restart it a few times it will find the drive but not find the modem load the game boot into the first portion where it tells you if you have high or low voltage then it goes to the calling it screen and stays there forever. I have a fresh copy of the complete hd and i have a secondary compact flash setup i was going yo use but i have to find my power cable first. I have 2.09 boot Rom and the right g4c chip.

lilshawn

  • Trade Count: (+3)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 7395
  • Last login:Yesterday at 11:47:13 pm
  • I break stuff...then fix it...sometimes
Re: Golden tee fore complete problem
« Reply #1 on: January 29, 2020, 02:22:21 pm »
i would check to see if there is crud shorting out some pins on the mainboard. check around the fine pins of the FPGA chips and CPU. crap dirt buildup on these chips can cause corrosion,shorts, and general randomness.

check your voltages. your 5 volts should be at least 5.0 to 5.2 or something like that. check your 12v as well... anywhwere from 11.5 to 12.5 ... or whatever is usually fine. if you have a read board...your 3.3 should be damn close to 3.3 volts.

also check these voltage with your meter set to AC. while it runs, you should have less than 30mv AC ripple in your 5v (and 3.3 if applicable) DC if it's up in the 100 or more, your power supply is putting too much noise in the system and needs to be replaced. ripple in your DC power can cause all kinds of randomness.

hold down the start button and power on the system... it should enter a test mode where you can do some rudimentary tests and see if there is something obvious going on through there