| Arcade Collecting > Restorations & repair |
| Ultimate mk3 controls not working |
| (1/3) > >> |
| tealsnk:
I recently purchased a ultimate mk3 pcb board, I installed into a mk4 cabinet. It boots up fine, however none of the joysticks and buttons work at all. I thought that that the kick harness for mk4 and umk3 would be the same and would be plug n play. Any ideas as to why the controls don't work at all. Thanks Sent from my SM-G955U using Tapatalk |
| Titchgamer:
If none of your controls are working at all the first thing I would check is the continuity of your ground loop for them. After that its cracking out the drawings and doing it wire by wire.... |
| tealsnk:
--- Quote from: Titchgamer on October 30, 2019, 02:45:32 am ---If none of your controls are working at all the first thing I would check is the continuity of your ground loop for them. After that its cracking out the drawings and doing it wire by wire.... --- End quote --- Ok, I may give that a try. Weird part is that mk4 ran great before. After not having any luck with the umk3 board controls I put the mk4 board back in and it plays perfectly. Maybe umk3 board issue? Sent from my SM-G955U using Tapatalk |
| Titchgamer:
Possibly a board issue or its wired totally different. Are they both Jamma boards? |
| tealsnk:
--- Quote from: Titchgamer on October 30, 2019, 07:13:39 am ---Possibly a board issue or its wired totally different. Are they both Jamma boards? --- End quote --- Yes, both are jamma boards. One thing I did notice is that the pin connectors on the umk3 board are very worn out where the jamma harness slides on. The silver on there is almost gone on quite a few. Not sure if that would cause the controls not to work. My understanding is thay mk3, umk3 and mk4 have all the exact same harnesses. Sent from my SM-G955U using Tapatalk |
| Navigation |
| Message Index |
| Next page |