Main > Lightguns
usb2gun pcb and windows 7 No y axis on gun 1
(1/6) > >>
vargas14617:
I have a usb2gun pcb when connected to pc gun 1 only works on x axis no y axis movement  gun 2 is fine.  I swap the guns same issue.  I am running a windows 7 pc.  tried it on xp machine and it worked.  Is there something I can do to get them to work in windows 7 or do I have to start over and use windows xp? 
Jollywest:
Following on from PM, it’s confirmed by others to work on XP and I have it working on 8.1. At least one other has tried Windows 7 but ran into problems with Calibration and Resolution according to original thread, not sure what the final outcome was.
Can anyone confirm they have this working in Windows 7 please?
It might be quicker to cut your losses and start again in XP or if possible upgrade to 8.1 and hopefully keep the work you’ve done so far on your system.
vargas14617:

--- Quote from: Jollywest on October 08, 2019, 01:47:37 am ---Following on from PM, it’s confirmed by others to work on XP and I have it working on 8.1. At least one other has tried Windows 7 but ran into problems with Calibration and Resolution according to original thread, not sure what the final outcome was.
Can anyone confirm they have this working in Windows 7 please?
It might be quicker to cut your losses and start again in XP or if possible upgrade to 8.1 and hopefully keep the work you’ve done so far on your system.

--- End quote ---

I see you say your running 8.1. Your original post is what inspired me to try this. So you switched from xp to &.1 did you notice any difference?  I will upgrade to 8.1 and report back.  Thanks a million.
Jollywest:
It was the initial plan but I never actually tried it on XP... can’t remember why I decided to go for 8.1  :dunno
vargas14617:

--- Quote from: Jollywest on October 08, 2019, 08:14:08 am ---It was the initial plan but I never actually tried it on XP... can’t remember why I decided to go for 8.1  :dunno

--- End quote ---

Tried windows 8.1. Noticed better tracking in gun 1.  But sometimes tracking in the calibration window would jump and I could not get the crosshairs into to bottom corners consistently. Is this normal?  I have not tried a game yet.   Next is to try a mame game. Any suggestions which to try first?
Navigation
Message Index
Next page

Go to full version