| Main > Lightguns |
| GUN4IR - The Ultimate 4 Points Lightgun System |
| << < (186/227) > >> |
| woordmand:
Ordinary rubber is OK. The hardness of waste automobile tires is more appropriate |
| holmes:
For PS4 rumble you can power it from the main USB cable, no issues ;D [/quote] Can I just cut a USB cable, split the power wires and resolder the data wires? Will it cause trouble with the data? Or is it safer to use a USB splitter data+power cable? |
| JayBee:
--- Quote from: holmes on November 19, 2021, 02:14:04 am --- For PS4 rumble you can power it from the main USB cable, no issues ;D --- End quote --- Can I just cut a USB cable, split the power wires and resolder the data wires? Will it cause trouble with the data? Or is it safer to use a USB splitter data+power cable? [/quote] No no you don't need to split it, just use the board "raw" and gnd pins ;) |
| Podbod:
Man, why did nobody say that mounting the x360 rumble in the handle of the topshot elite was so hard! I've melted all of the plastic and made it as flat as possible and there still not enough room! :D Going to have to melt out a recess in the 2mm thick wall and hope I dont burn through the whole handle. Did Arcade Pirate use a rumble motor that was 80% in size? :D Pod |
| Podbod:
Phew, all assembled. Next step, working out mame hooker and getting the gun swapped from com6 to com1 |
| Navigation |
| Message Index |
| Next page |
| Previous page |