| Main > Main Forum |
| Drilling through sheet metal |
| << < (2/2) |
| flampoo:
I have a hard time dropping $35 on a bit I'll rarely use. |
| SirPeale:
Sell it after you're done. |
| mp2526:
Right, you can usually get $10-20 bucks for it on eBay, or I'm sure someone around here would buy it off you. |
| Rocky:
I took my metal CP to a sheet metal shop in town and had them punch the holes for me. It cost less than $35 for one bit :o Rocky |
| paigeoliver:
I agree, buy it, use it for what you need it for, and I will buy it from you for $10 if no one else bids higher. Or even better, just keep it, as you can NEVER have too many tools! |
| Navigation |
| Message Index |
| Previous page |