Main > Main Forum

Drilling through sheet metal

Pages: (1/2) > >>

flampoo:

I assume a hole saw will do the trick for pushbuttons? The metal is only 1/8" thick, as is with most metal panels. And is it wrong for me to assume that the sheet metal is NOT stainless steel? Because I know I'll need a different type bit for harder metals.

Stingray:

You'll need a different type of hole saw than the one you used for wood regardless of the metal type. Most hole saws that are made for wood will barely scratch metal. Just make sure you're using the right type of hole saw and you shouldn't have a problem.

-S

mp2526:

Or as has been pointed out several times on this forum, you might try a Greelee hole punch.  They are much easier to work with.

Stingray:

I think you mean Greenlee, and I agree they do look very handy. I really should buy one before I start my next panel.

-S

mp2526:


--- Quote from: Stingray on February 12, 2004, 02:27:26 pm ---I think you mean Greenlee, and I agree they do look very handy. I really should buy one before I start my next panel.

-S

--- End quote ---

Your right, didn't proof read my last post, it's Greenlee

Pages: (1/2) > >>

Go to full version