Arcade Collecting > Merit/JVL Touchscreen

Megatouch XL Bartop Monitor Not Working

(1/2) > >>

ice2921:
I recently picked up a megatouch xl bartop system that would not boot. The system would POST but fail on no boot device found. Since these devices depend on the CD-ROM, i figured that was a good start. I pulled everything out and replaced the CD-ROM drive. I put it back together and now the monitor won't display anything. I know its getting power because when I turn it off it lights up. I also hear a speaker like tick over and over once i turn it on. Not sure what's going on here. I was pretty careful when I put it back together. One thing I did do was clean the CPU fan it was filled with gunk and the fan was making noise. I thought maybe I set it in wrong but i reseated it a couple of times with no joy. I also removed the mainboard and IO card to and cleaned them still no joy.

Megatouchmike:
Here is the response I emailed you, but you never responded:

Remove the I/O board and riser.  Clean the contacts with a pencil eraser.  Push down gently on all the EEPROMs on the I/O board and motherboard, then reinstall the I/O board and riser.  A lot of times, these chips just are making bad contact and pushing them back down fixes a lot of issues.

ice2921:
Didn't get a chance to get. As my last sentance stated I tried that and its still not working.

ice2921:
I also made sure the EEPROM was seated correctly.

ice2921:
Tried again nothing. I dont understand what would be making the monitor all of a sudden stop working.

Navigation

[0] Message Index

[#] Next page