Software Support > GroovyMAME
GroovyArcade live-CD 2022 (collaborative effort)
Diogo:
Sorry for the trouble but I have one more question: How do I connect Groovyarcade to the internet to update? Just connect the RJ45 cable to the rear port of the computer? Should I do some more procedures? Please help this newbie here...
Diogo:
I installed the 2023 version of GroovyArcade but I can't find my pendrive on the system, even though I left the show connected volumes on thne desktop option checked.
Substring:
--- Quote from: Diogo on December 18, 2023, 05:32:02 pm ---Sorry for the trouble but I have one more question: How do I connect Groovyarcade to the internet to update? Just connect the RJ45 cable to the rear port of the computer? Should I do some more procedures? Please help this newbie here...
--- End quote ---
gasetup > setup > system update > full system update
pigzaj2:
Looking for some assistance here. I am in process of trying to test the groovy arcade iso usb with my HD6450. I have my lcd monitor plugged into dvi and my vga connected into a vgactv2 which is plugged into the YPP component in on sony crt. I have tried the various settings on the live cd installer and none of them will output 15khz to the transcoder. The transcoder has led on it to show it's receiving a 15khz signal or 31khz signal or no signal and when turning on the VGA output, the transcoder will not receive a 15khz signal (shows no signal). is there a cfg setting or something i am missing? I also messed with an old amd card and flashing the bios to output 15khz which worked initially.. but when the live usb runs, it is never able to output 15khz to the transcoder.
later edit: After some more troubleshooting. The roms will load and display in 15khz, but nothing else will. Attract mode and the gasetup tool are in a higher res.
Thanks,
John
Calamity:
--- Quote from: pigzaj2 on January 09, 2024, 01:35:52 pm ---Looking for some assistance here. I am in process of trying to test the groovy arcade iso usb with my HD6450. I have my lcd monitor plugged into dvi and my vga connected into a vgactv2 which is plugged into the YPP component in on sony crt. I have tried the various settings on the live cd installer and none of them will output 15khz to the transcoder. The transcoder has led on it to show it's receiving a 15khz signal or 31khz signal or no signal and when turning on the VGA output, the transcoder will not receive a 15khz signal (shows no signal). is there a cfg setting or something i am missing? I also messed with an old amd card and flashing the bios to output 15khz which worked initially.. but when the live usb runs, it is never able to output 15khz to the transcoder.
later edit: After some more troubleshooting. The roms will load and display in 15khz, but nothing else will. Attract mode and the gasetup tool are in a higher res.
Thanks,
John
--- End quote ---
You have to force a 15 kHz EDID binary in the kernel boot line, force that output (vga) as enabled, and maybe also disable the output to your LCD monitor.
In syslinux.cfg:
monitor=generic_15 video=VGA-1:e drm.edid_firmware=VGA-1:edid/generic_15.bin
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version