Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Mortal Kombat bootleg pcb speaker question  (Read 2917 times)

0 Members and 1 Guest are viewing this topic.

amiga500

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 85
  • Last login:January 28, 2024, 03:02:32 pm
Mortal Kombat bootleg pcb speaker question
« on: March 19, 2019, 09:26:29 pm »
Not sure if this is the right section to ask this, but I would like to know what kind of speaker (ohms, Watts) should I add to this board without damaging it or the speaker itself.
The amp on the board is a uPC1241H, I've found some info that says it's a 5 to 11w amp and that it can manage a 2 Ohm to 4 Ohm load ??
I'm not sure I understand what the datasheet says, so, what is the most suitable speaker I could connect to this board?
Could I connect 2 speakers? How?

here is some info about the amp: http://malzev.tripod.com/comp/upc1242.htm
Datasheet: https://cdn.datasheetspdf.com/pdf-down/U/P/C/UPC1241H_NECElectronics.pdf

Thanks!
« Last Edit: March 19, 2019, 10:12:46 pm by amiga500 »

RV88

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:April 25, 2019, 11:48:44 am
  • I want to build my own arcade controls!
Re: Mortal Kombat bootleg pcb speaker question
« Reply #1 on: April 25, 2019, 11:47:18 am »
Hello,

On your schematic, I can See speaker output: 4ohms. It's the minimal value, you can ad.
You can put two speakers but the minimal ohms will be 8hms, because you will connect them in parallel, which make them as a single speaker with 4 ohms load.
and uPC1241H is a mono output