Main > Meet-Up
Party at Mike's part 2
<< < (3/10) > >>
Mike A:
Thank you for the information. I will look into that.
pbj:
Pop off the bulb from your desoldering iron, put some tubing on it, and run the tubing to a shopvac.  Control the shopvac with a foot pedal (constant air flow will make the tip too cold).  As mentioned, melt a little fresh solder on everything first.  You'll make quick work out of it.

 :cheers:
Mike A:
That sounds good. I have tubing and I have a shop vac. I will give it a shot.
yotsuya:
Bro, just buy a Hakko. Don’t Jim it up. :cheers:
pbj:
Meh, $20 versus $200 for a tool you're gonna use twice.

Navigation
Message Index
Next page
Previous page

Go to full version