Arcade Collecting > Pinball

Jennifer "Hot" new pin...Part 2

<< < (20/38) > >>

jennifer:
 :)

jennifer:
 :)

Nephasth:
On the subject of cutting the T-molding slot... For those new to the task... It helps to set the depth of the router bit, lock it in, then turn the router on for a bit, turn it off and make sure your bit depth did not change. Also, check that depth a few times while cutting, just to make sure the bit isn't drifting. In other words... Tighten the ever-loving piss out of the bit.

jennifer:
 :)

jennifer:
 :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page