New guy asking for some guidance

[Nylkos]

Hi, I used to play a lot of Roms, stopped about 14 years ago (first kid), but the switch and it's free retrogaming had me hooked again.

I am planning to build an arcade cabinet with light-guns (I still own 2 Guncon 2 and 1 Guncon). ATM I do own a Raspberry Pi B+, a few old PC and a CRT TV.
In other terms I am equipped to go in most directions, but I would like to use what I have.

I am posting this because I did a lot of research and found a lot of different info about Guncon and some time I am even unsure if it'S for PC, Raspberry Pi or anything else.

So far:

• I found the Windows 10 drivers in the following thread: http://forum.arcadecontrols.com/index.php?topic=154492.0 which allow me to shoot at my icons, but haven't found how to use it with Attract Mode
• I was unable to find the required drivers for Linux.

Does anyone have a link about how to use such light guns from beginning to the end?

Thank you

[Nylkos]

I tested with Demul and some dreamcast games that I already own.

Sadly and strangely, in both case, the cursor is in the right spot (where I am aiming), but I when I shoot it hit a few cm to the left...
Anyone wknos how to fix this issue?

[ark_ader]

So are you using a EMS TopGun?

[Nylkos]

So are you using a EMS TopGun?

No, I am using a Windows 10 driver made from a forum member, the link is in my first post.

Like mentionned the issue that I have is the cursor is well calibrated, but when I shoot it doesn't shoot on the cursor, it shoots a few cm to it's left...