To lubricate my U360s, I’ve read that I should use silicon paste.
Do I have to take it completely apart and out of my control panel?
Or can I do it through the back by just removing the circuit boards?
Also exactly where do I put the lube?
Do I goop it on or just put on at little and spread it around a bit?
On the spintraks, I have two. One will easily spin for 20 seconds?
The other only
I have a fly wheel on both if it matters?
Is their any spot that should be lubed on these?
If so, what kind of lube and where do you put it?
Thanks
Freddy