Main > Woodworking

T-molding cut drifts from center after lengthy cut

<< < (3/3)

bperkins01:
Another thing that can be happening is never push the router bit 'ALL THE WAY' into the collet. Push it in, then  back it out a little.  If you bottom it out - it will not tighten properly - and is likely spinning loose..

morton:

--- Quote from: bperkins01 on November 23, 2018, 08:25:47 am ---Another thing that can be happening is never push the router bit 'ALL THE WAY' into the collet. Push it in, then  back it out a little.  If you bottom it out - it will not tighten properly - and is likely spinning loose..

--- End quote ---

Where were ya when I needed you last summer? Haha

Navigation

[0] Message Index

[*] Previous page