Hello,
I programmed a promicro 32u4 with lwclone2u software and that seemed to work well. Not sure why there was an EEPROM file from the build. All the pin setup seems to be in the pin.h file. For this round, I left the pin.h file as is.
Device manger sees seven devices. The 'keyboard' input pins work. The analog inputs work in Mame, but I couldn't see the analog in the Kade padtest program. Is there a different padtest that works with lwclone2u?
The part that I can't test is the LED outputs. The pin.h says two LED are setup, the onboard TX and RX leds.
I tried turning the LEDs on with mamehooker command test and LWsend.exe
Here is the pin.h section that mentions LED
#define LED_MAPPING_TABLE(_map_) \
/* the following corresponds to the Arduino Leonardo mapping */ \
\
_map_( B, 0, 1 ) /* RX LED */ \
_map_( D, 5, 1 ) /* TX LED */ \
\
/* end */
These are the right pins for the LED. I assume this is LED 1 and LED2.
Any advice on what to try next?