There is a belt sander behind that light.... I do NOT recommend buying one, That one is heavily modified, and right out of the box was so bad it vibrated horribly to the point it tried to eat itself, and actually bent the main shaft. the five year warranty was the selling point for me, but not much help and after the third try was getting used parts, and a very direct lectures on how great there machines are by some salesman who apparently has never even used one.... This machine was mounted on a restored craftsman band saw stand ,And completely gone through, motor was replaced with a farm duty 3 ph , with a vfd (for variable speed) given the original was poorly aligned open frame , the main shaft was turned from stainless, to adapt a Jet disk plate ( the one it came with was thin flimsy, and out of balance, which was attempted to be addressed at the factory by back drilling balancing divots on the back...EPIC FAIL..., The top plate was modified for a stainless dust collector (I threw all that cheesy ABS plastic into the recycle) and finally found the original problem which was a bad pulley casting half of it was actually hollow (found that out by cutting it in half) warranty sent me a apparently used pulley with the SAME poor half hollow casting problem. at this point they wanted nothing more to do with me in terms of my forensics....Do not buy one unless you want to spend a year and a half of redesigning, (and more that double your initial cash outlay in parts) to make it even usable.