Hello everyone
I recently purchased two Aimtrak guns with recoil pre-installed from Ultimarc. As you might be aware, they do not ship with the power supply for the recoil.
Well, as giddy as I am, i tried to use the gun without the PSU, and neither of the two work (I tried both sensor bars). They see the LEDs "sometimes" (as in, only close up, at the "top", but as soon as i point to my screen, nada... also, i tried turning the screen off, and using dual screens to just duplicate them, to see if my Screen with interferring, but seemingly not).
I checked the Sensor bar that the IR lights are on (using a mobile phone camera), and they do. (Side note: I tried the IR bar on my TVīs usb, and it lit up alot weaker than it does when i plug it into a dedicated USB port, or even USB power adapter (1A or 2A) to which i resorted then.
Anyhow, down to my question, is the Power supply required to calibrate the gun or that the gun seeīs the bar properly if a recoil kit is installed? If so, I would know where my problem lies,
if not... any advice on what to test/try to troubleshoot and possibly fix it, would really be appreciated.
Thanks in advance