Hello there, I want to know how many 20ma LED I can connect (safely) to the ( + ) anode and cathode?
Basically I what to have two (and also four) LEDs connected to the same Outputs (+RGB)
Parallel? serial?
Thank you
Not sure if this helps but...
From Ultimarc:
“The voltage required depends on LEDs being used but all LEDs supplied by Ultimarc require 5 volts and the supplied power cable is pinned for 5 volts.
Current requirement is 0.02 amps X number of LEDs. Note each RGB LED counts as 3 LEDs.”
Or are you asking if daisy-chaining LED’s is going to somehow mess up your connector?