Hi techoff2,
I suggest that you check the miscro switches again, if the transfer motor is in the play position it should should not reject unless a cancel button is pressed or the auto cutoff is activated by an incorrect cut off screw.
With regards to the cam switches check that none of the uninsulated spades are not touching each other (this is a common fault both on the 1100, 1200 and the two cam swithes on the R-84 mechanism upwards).
I would check the mechanism control for any burnt out resistors and the triacs used on the board.
We still do repairs on these boards, in fact we sent a set of boards we had repaired back to the USA yesterday for a customer.
Regards
Alan
Alan Hood
ami-man
UK