Main Board: 05A00585D1
Tube: A68KJU96X
B+ is at 76V
All Electrolytic Caps have been replaced except the big filter cap
Pots are measuring to factory spec
Problem: The horizontal position is maxed, but will not center (2" from top, shown in 3nd picture). If i keep moving the horizontal hold, there is a second spot where the picture locks. This one has a very noticeable curl, and cannot be centered vertically (0.5" from the right, shown in 2rd picture). I have tried use the Wide and Narrow jumper on the chassis with pretty much no difference. If the monitor has been sitting for a while it has a bend (shown in first picture) in the top left and right sides which straightens out in under a minute. Any help getting rid of the curl or centering the picture will be appreciated.
Here is a video of me slowly going through the entire horizontal hold:
When this chassis is swapped out with a different newer revision of the MS9 ( 05A00675C1 ) everything works as it should.
Also with the 05A00585D1 the blue and red convergence is off by few pixels (you can really see the red in the black text box at the bottom) and the 05A00675C1 looks perfect. Is this normal when swapping between chassis? or is it an indication of another underlying problem?