Using J-PAC with an Makvision M2725C-82 monitor

[alex_bb23]

Hello guys,

I own an Makvision M2725C-82 monitor which (according with technical specifications) can support resolutions 320 x 240 / 640 x 200. I intend to use this in combination with CRT Emudriver 2.0... So, windows desktop can run at 640 x 480i and I'm not sure if this monitor can be capable to deal with this resolution... Could somebody tell me if this will work?

Thank you!

[buttersoft]

It should work fine. Some sets handle interlaced modes better than others, with less flicker, but there's not normally a lot you can do about that.

And BTW you probably wanted to post this in the monitor/video section

[alex_bb23]

It should work fine. Some sets handle interlaced modes better than others, with less flicker, but there's not normally a lot you can do about that.

Thanks to the ATI 5450 there is less flicker.

And BTW you probably wanted to post this in the monitor/video section

You're right! Could somebody move this post in the monitor/video section?

Thank you!