Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: generate mame xml for LEDBlinky  (Read 2000 times)

0 Members and 1 Guest are viewing this topic.

Hutt

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 174
  • Last login:December 31, 2022, 11:02:48 am
  • I like eggs.
generate mame xml for LEDBlinky
« on: April 07, 2018, 08:22:53 pm »
Switching from HS to Launchbox and making some other upgrades to the cabinet at the same time.
Just updated from mame 147 to 195.
Generated a mame.xml for use with LEDBlinky.... it's over 200 meg... previous one for 147 was still 133meg.
Can I generate a file based on the roms I actually have? I only have a little under 200

The big problem with this is if I have LEDBlinky preload it then it throws my light timing off for the initial LB launch.
If I don't preload it the first time I select the MAME platform it must wait until then to load because my lighting is thrown off for a good 30 seconds at that point.
If I had an xml for only what I need it would probably be under 5 meg.
Logged
Pages: [1]
  
Go Up
« previous next »