Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Need help: sega hang on accelerator spring installation  (Read 2111 times)

0 Members and 1 Guest are viewing this topic.

rob1234

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 338
  • Last login:September 23, 2022, 07:40:58 am
  • I'm a llama!
Need help: sega hang on accelerator spring installation
« on: April 14, 2018, 08:35:02 pm »
I am trying to reassemble a sega hang on accelerator handle. I can’t figure out the tension spring on how to get it into the plastic housing. Does anyone have any pictures showing the spring placement?
« Last Edit: April 14, 2018, 08:41:58 pm by rob1234 »

rob1234

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 338
  • Last login:September 23, 2022, 07:40:58 am
  • I'm a llama!
Re: Need help: sega hang on accelerator spring installation
« Reply #1 on: April 14, 2018, 09:15:18 pm »
I am trying to reassemble a sega hang on accelerator handle. I can’t figure out the tension spring on how to get it into the plastic housing. Does anyone have any pictures showing the spring placement?

The issue is similar to the thread below

https://forums.arcade-museum.com/showthread.php?t=406489

white_ghost

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 20
  • Last login:Yesterday at 02:32:08 am

rob1234

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 338
  • Last login:September 23, 2022, 07:40:58 am
  • I'm a llama!
Re: Need help: sega hang on accelerator spring installation
« Reply #3 on: April 15, 2018, 07:42:02 am »
i figures out the issue. You need to start with the accelerator handle upside down. Rotate the handle 180 degrees clockwisewith the spring installed to put tension on the spring then install the other half of the casing.
« Last Edit: April 15, 2018, 08:47:47 pm by rob1234 »