| Arcade Collecting > Restorations & repair |
| Control Panel Vinyl Repair |
| (1/1) |
| Lamaman1971:
Hi Folks, Ive got an old wooden CP with a nice Vinyl Graphic. Unfortunately it looks like a wood screw has been driven through the underside and has, very slightly, poked the sharp end out the Vinyl. I dont want to spend money on replacement graphics (as it isnt mine) - the hole is tiny. Does anyone have any ideas? The Vinyl looks to be good quality and has raised up around the hole a little creating a tiny dimple - it would be nice to try and at least flatten it down a little so its less noticeable. Any ideas? |
| Joemustang65:
Maybe you can inject some glue with syringe and needle? I have used that to flatten air bubbles on wallpaper And probably you can put the needle through the screw hole . Then flatten bubble with credit card |
| Joemustang65:
Dimple could also be some wood chip underneath. In that case you might need to make a small cut in vinyl to remove chip. |
| Navigation |
| Message Index |