I was able to test the D1880 and C3306 and both seem to be ok using the instructions below. The values were not all exact as what are mentioned below but pretty close... everything needing to show OL showed OL. Would the flyback go before these transistors? I don't see any evidence of any damage on the board, and I already performed a full recap and i keep blowing fuse F901. Thank you.
Take those transistors out of the circuit , with the DMM set for diode measuring and the following values are what I read from my known good transistors
Q901:
Red test lead to B,black to C: .499
============B,===== E: .536
Black test lead to B,red to C: OL
============ B, ==== E: OL
Red test lead to C,black to E: OL
Black test lead to C,red to E: OL
Q533:
Red test lead to B,black to C:.452
=========== B,====== E:.027
Black test lead to B,red to C: OL
============ B,===== E:.027
Red test lead to C,red to E:OL
Black test lead to C,red to E:.464